diff --git a/docs/configure.txt b/docs/configure.txt
index 58830c2d..200c9966 100644
--- a/docs/configure.txt
+++ b/docs/configure.txt
@@ -1,27 +1,34 @@
-There are serval macros available to configure the behaviour of the GFX-Library.
-
-HAL macros:
-
-	#define HAL_USE_GFX					// enables the GDISP sub system. This is essentially needed to use the display
-	#define HAL_USE_TOUCHPAD			// enables the TouchPad sub system. This is essentially needed to use the touchpad
-
-
-
-GDISP macors:
-
-	#define GDISP_USE_GPIO				// GDISP is connected to the MCU using GPIO interface, involves using lld_lcdWriteGPIO() and lld_lcdReadGPIO()
-	#define GDISP_USE_FSMC				// GDISP is connected to the MCU using FSMC interface
-	#define GDISP_USE_SPI				// GDISP is connected to the MCU using SPI interface
-
-	#define GDISP_SCREEN_WIDTH			// defines width of panel in pixels
-	#define GDISP_SCREEN_HEIGHT			// defines height of panel in pixels
-
-	#define GDISP_NEED_MULTITHREAD		// GDISP will be accessed across different threads -> thread safe support 
-	#define GDISP_NEED_CONTROL			// must be set to TRUE if access control access to the LCD controller is needed
-
-
-TouchPad macros:
-
-	#define TOUCHPAD_
-
-
+There are serval macros available to configure the behaviour of the GFX-Library.
+
+HAL macros:
+
+	#define HAL_USE_GFX					// enables the GDISP sub system. This is essentially needed to use the display
+	#define HAL_USE_TOUCHPAD			// enables the TouchPad sub system. This is essentially needed to use the touchpad
+
+
+
+GDISP macors:
+
+	#define GDISP_USE_GPIO				// GDISP is connected to the MCU using GPIO interface, involves using lld_lcdWriteGPIO() and lld_lcdReadGPIO()
+	#define GDISP_USE_FSMC				// GDISP is connected to the MCU using FSMC interface
+	#define GDISP_USE_SPI				// GDISP is connected to the MCU using SPI interface
+
+	#define GDISP_SCREEN_WIDTH			// defines width of panel in pixels. This is essentially needed to use the display
+	#define GDISP_SCREEN_HEIGHT			// defines height of panel in pixels. This is essentailly needed to use the display
+
+	#define GDISP_NEED_MULTITHREAD		// GDISP will be accessed across different threads -> thread safe mode 
+	#define GDISP_NEED_CONTROL			// must be set to TRUE if controll access to the LCD controller is needed, eg for changing orientation or power mode
+
+
+
+TouchPad macros:
+
+	#define TOUCHPAD_NEED_MULTITHREAD	// TouchPad will be accessed across different threads -> thread safe mode
+	
+	#define TOUCHPAD_XY_INVERTED		// output of tpReadX() and tpReadY() swapped - needed if touchpad writes swapped to touchpad controller
+
+	#define TOUCHPAD_STORE_CALIBRATION	// calibration values can be stored if set to true. Therefore tpCalibration() is not neccessary to call on each reset. involves using lld_tpWriteCalibration() and lld_tpReadCalibration()
+
+	
+
+