ugfx/drivers/ginput/touch/STMPE610/gmouse_lld_STMPE610_board_t...

61 lines
1.8 KiB
C

/*
* This file is subject to the terms of the GFX License. If a copy of
* the license was not distributed with this file, you can obtain one at:
*
* http://ugfx.org/license.html
*/
#ifndef _GINPUT_LLD_MOUSE_BOARD_H
#define _GINPUT_LLD_MOUSE_BOARD_H
// Resolution and Accuracy Settings
#define GMOUSE_STMPE610_PEN_CALIBRATE_ERROR 8
#define GMOUSE_STMPE610_PEN_CLICK_ERROR 6
#define GMOUSE_STMPE610_PEN_MOVE_ERROR 4
#define GMOUSE_STMPE610_FINGER_CALIBRATE_ERROR 14
#define GMOUSE_STMPE610_FINGER_CLICK_ERROR 18
#define GMOUSE_STMPE610_FINGER_MOVE_ERROR 14
// How much extra data to allocate at the end of the GMouse structure for the board's use
#define GMOUSE_STMPE610_BOARD_DATA_SIZE 0
// Options - Leave these commented to make it user configurable in the gfxconf.h
//#define GMOUSE_STMPE610_READ_PRESSURE GFXOFF
//#define GMOUSE_STMPE610_SELF_CALIBRATE GFXOFF
//#define GMOUSE_STMPE610_TEST_MODE GFXOFF
// If GFXON this board has the STMPE610 IRQ pin connected to a GPIO.
// Note: For tested hardware this is unreliable and should be set to GFXOFF until tested.
// Symptoms are that mouse readings just appear to stop for a bit. Lifting the touch
// and re-applying the touch cause readings to start again.
#define GMOUSE_STMPE610_GPIO_IRQPIN GFXOFF
// If GFXON this is a really slow CPU and we should always clear the FIFO between reads.
#define GMOUSE_STMPE610_SLOW_CPU GFXOFF
static gBool init_board(GMouse* m, unsigned driverinstance) {
}
#if GMOUSE_STMPE610_GPIO_IRQPIN
static gBool getpin_irq(GMouse* m) {
}
#endif
static GFXINLINE void aquire_bus(GMouse* m) {
}
static GFXINLINE void release_bus(GMouse* m) {
}
static void write_reg(GMouse* m, uint8_t reg, uint8_t val) {
}
static uint8_t read_byte(GMouse* m, uint8_t reg) {
}
static uint16_t read_word(GMouse* m, uint8_t reg) {
}
#endif /* _GINPUT_LLD_MOUSE_BOARD_H */